Offline
Forum
CS2D General Bug: Spraylogo Display Error
Bug: Spraylogo Display Error
3 replies
1 
You should try to make a logo that is just 1px horizontal lines from top to buttom with only 1px spacing in between each line. If my idea is correct it should end up being just a 32x32 square.
DC should have a look at this
edited 1×, last 26.02.12 03:19:23 pm
Quote
Please note the following for custom sprays:
Each spraylogo has to have a size of 32x32 pixels!
BMP is the recommended format for spraylogos.
You should only use grayscale images for logos!
- Black -> will become transparent
- Gray -> will become semi-transparent
- White -> will become opaque
WARNING: SPRAYLOGOS WHICH ARE BIGGER OR SMALLER THAN
32X32 PIXELS WILL CAUSE ERRORS! DO NOT USE SUCH
SPRAYLOGOS! THEY WILL KILL YOU! OH - MY - GOD!
WARNING: DEDICATED SERVERS REQUIRE THIS FOLDER IF
SPRAYLOGO TRANSFER IS ENABLED! SO MAKE SURE THAT
IT EXISTS IN THAT CASE!
Each spraylogo has to have a size of 32x32 pixels!
BMP is the recommended format for spraylogos.
You should only use grayscale images for logos!
- Black -> will become transparent
- Gray -> will become semi-transparent
- White -> will become opaque
WARNING: SPRAYLOGOS WHICH ARE BIGGER OR SMALLER THAN
32X32 PIXELS WILL CAUSE ERRORS! DO NOT USE SUCH
SPRAYLOGOS! THEY WILL KILL YOU! OH - MY - GOD!
WARNING: DEDICATED SERVERS REQUIRE THIS FOLDER IF
SPRAYLOGO TRANSFER IS ENABLED! SO MAKE SURE THAT
IT EXISTS IN THAT CASE!
in case it actually is 32x32 pixels grayscale: sorry, no idea how this happens. bad voodoo stuff must be involved!
other people servers whose maps had too many things...
1